Snap Modes > Corner / End Point (Extra Menu)

The snap modes determine which type of point should be used as a snapping reference. There are various snap modes, some of which can be used together. The snap modes take effect when snapping is active. Snapping can be turned on or off using the F6 Key or the first button in the Panel. It can be temporarily (de)activated during point entry using the SHIFT key.

This snap mode can be used to insert snapping reference points at the corners and ends of objects. These are the end points of lines, curves, circle and ellipse arcs, dimension lines and hatching lines, as well as corner points within curves, surfaces, circle sectors, circle segments, ellipse sectors and ellipse segments. To snap to such a point, simply click near it.

Optionally, this snap mode can be turned on or off by left-clicking the button in the panel shown above. In addition the button always shows the snap mode's current status.