Snap Modes > Intersection (Extra Menu)

The snap modes determine which type of point should be used as a snapping reference. There are various snap modes, some of which can be used together. The snap modes take effect when snapping is active. Snapping can be turned on or off using the F6 Key or the first button in the Panel. It can be temporarily (de)activated during point entry using the SHIFT key.

This snap mode can be used to place snapping reference points at intersections within objects. If the "Construction Aid" snap mode is active at the same time, snapping reference points can also be placed at the intersections of objects with the Construction Aid and (if present) reference objects. To place a snapping reference point on an intersection, simply click near it.

Optionally, this snap mode can be turned on or off by left-clicking the button in the panel shown above. In addition the button always shows the snap mode's current status.