MKD Syntax

The section =EXIT= contains a CRC ("cyclic redundancy check") value calculated over the whole file. It is used to terminate a MKD file. After reading the semicolon behind =END=, the interpretation of the file is finished.

=EXIT=;

-CRC-

=END=;

If you are creating MKD files manually, i.e. without using the CAD6interface, be sure to use 0 as CRC value, otherwise the application will report an invalid CRC upon opening the file.

Files that have a CRC of 0 or an invalid CRC cannot be loaded with an unregistered trial version or with CAD6starter unless in read-only mode!