Ellipse > Vector - Vector (Draw Menu)

This command draws a ellipse by entering both half-axes independently so that they can be at any angle to each another.

The center point of the ellipse can be entered with the mouse by clicking at any point in the drawing.

The first point through which the ellipse should run is the end point of the first half axis. It can be entered with the mouse by clicking anywhere in the drawing.

The second point through which the ellipse should run is the end point of the second half axis. It can be entered with the mouse by clicking anywhere in the drawing.

The ellipse is assigned to the current layer. It also contains a reference to the current pen.