Surface / Curve > Edit (Trim Menu)

An existing curve or surface can be edited using this command. Elements can be inserted, transformed or deleted.

Single points on a curve / surface (End points, corner points, and pivot points) can be moved using the command Move Single Point.

The position at which the curve / surface is identified (the "ID point"), affects the rest of the command. It determines which end of the curve / surface should be edited or at which point an element should be inserted.

After identifying the curve / surface, a popup menu appears, in which the action can be chosen which will be carried out with the element or joint of the curve / surface which is nearest to the ID point. The further progress of the entry depends on which command is chosen in this menu.

Polylines, freehand lines and polygons are stored internally as curves / surfaces and can therefore be manipulated with this command. All other objects must, if necessary, be converted to a curve or surface using the commands Transform Objects to > Curve and Transform Objects to > Surface.