![]() |
Parameter Window (Screen Elements) |
www.CAD6.com |
The parameter window will be displayed automatically in the main drawing window once the current commend offers parameters or options.
The number and type of buttons depends on the respective command. Possible buttons are:
The current command offers parameter the can be edited by clicking this button, see Edit Parameters (+ESC)
Finishes the current command and applies the data entered, see Finish Command
Cancels the current command and discards the data entered, see Cancel Command
Revokes the previous point's entry, see Previous Point (ESC)
Switches the extended identification on or off, see Extended Identification on/off
Cancels the current identification, see Cancel Identification
Identifies all objects, see Identify All (F10)
Identifies the previously used set of objects again, see Previous Identification (F11)
Selects all objects currently visible in the drawing window, see Identify Window Contents
Selects all objects in a rectangular area of the drawing, see Identify Area, Rectangle
Selects all objects in a polygonal area of the drawing, see Identify Area, Polygon
Switches the area mode »Jutting Into« on or off, see Area Mode »Jutting Into« (+F6)
Calls Temporary Line > Point - Point
Calls Temporary Circle > Center - Poin on Circle
Switches the temporary override for lock and idle modes of all pens and layers on or off, see Override Lock and Idle
Switches the selection filter on or off, see Selection Filter (0)
Switches the orthogonal mode on or off, see Orthogonal Mode (F5)
Switches snapping on or off, see Snap Active (F6)
Switches duplicate function on or off, see Duplicate / Multiline (F7)
Switches multiline function on or off, see Duplicate / Multiline (F7)
Switches between horizontal and vertical orientation for some dimension types
Switches between smaller and larger arc for some dimension types
Switches the hollow preview mode on or off
Calls the temporary objects menu, see Temporary Objects
Calls the numeric coordinate entry, see Coordinate Entry (F8)
Context MenuThe parameter window has a context menu from which certain settings relating to it can be changed. Right-click inside the window to open it. The following commands are available:
Small IconsIf this menu entry is checked, small icons (24 × 24 pixels) will be displayed in the button. Otherwise, standard icons (40 × 40 pixels) will be displayed.
Window PositionThis submenu can be used to determine the desired position of the parameter window.
|
CAD6studio Release 2025.0 - Copyright 2025 Malz++Kassner® GmbH